LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Mechanical - 3.6L (5 Of 5)) >> Off-Vehicle Repair Instructions (3 Of 3) >> Engine Flywheel Installation >> Installation

Engine Flywheel Installation: Installation

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the engine flywheel in position on the crankshaft.
  2. Install 2 NEW bolts in location at the top and bottom of the engine flywheel bolt pattern allowing the engine flywheel to hang in position.
    3. Fig 1: View Of Special Tool EN 46106
    GM945978Courtesy of GENERAL MOTORS CORP.
  3. Install the EN 46106  . See Special Tools .
    4. Fig 2: Identifying Engine Flywheel Bolts
    GM1395957Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the remaining NEW engine flywheel bolts.

    Tighten: 

    1. Tighten the NEW engine flywheel bolts to 30 N.m (22 lb ft).
    2. Tighten the NEW engine flywheel bolts an additional 45 degrees using the J 45059  .

    5. Fig 3: View Of Special Tool EN 46106
    GM945978Courtesy of GENERAL MOTORS CORP.
  5. Remove the EN 46106  . See Special Tools .
scientia non olet · About LEMON Manuals