LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Engine Mechanical - 3.6L (3 Of 5)) >> Off-Vehicle Repair Instructions (1 Of 3) >> Water Pump Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Special Tool - EN 46104
    GM1855657Courtesy of GENERAL MOTORS CORP.
  1. Install the EN 46104  (1) onto the water pump pulley.
    2. Fig 2: View Of Water Pump Pulley & Bolts
    GM1855658Courtesy of GENERAL MOTORS CORP.
  2. Remove the water pump pulley bolts.
  3. Remove the water pump pulley.
    4. Fig 3: View Of Water Pump, Gasket & Bolt
    GM1855659Courtesy of GENERAL MOTORS CORP.
  4. Remove the water pump bolts.
  5. Remove the water pump from the front cover.
  6. Remove the water pump gasket.
scientia non olet · About LEMON Manuals