LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Engine Mechanical - 3.6L (3 Of 5)) >> Off-Vehicle Repair Instructions (1 Of 3) >> Engine Flywheel Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Tool EN 46106
    GM945978Courtesy of GENERAL MOTORS CORP.
  1. Install the EN 46106  through the starter mounting hole. See Special Tools .
    2. Fig 2: Identifying Engine Flywheel Bolts
    GM1395957Courtesy of GENERAL MOTORS CORP.
  2. Remove the engine flywheel bolts and discard.
  3. Remove the engine flywheel from the crankshaft.
    4. Fig 3: View Of Tool EN 46106
    GM945978Courtesy of GENERAL MOTORS CORP.
  4. Remove the EN 46106  . See Special Tools .
scientia non olet · About LEMON Manuals