LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Engine Mechanical - 3.6L (3 Of 5)) >> Off-Vehicle Repair Instructions (1 Of 3) >> Camshaft Position Actuator Removal - Left Side Intake (Fourth Design)

Camshaft Position Actuator Removal - Left Side Intake (Fourth Design)

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Camshaft Position Actuator Bolt
    GM1852296Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Torque Reaction Against Timing Drive Chain Notice .
  1. Use an open wrench on the hex cast into the camshaft in order to prevent engine rotation when loosening the camshaft position actuator bolt.
  2. Remove the left intake camshaft position actuator bolt.
  3. Remove the left intake camshaft position actuator.
scientia non olet · About LEMON Manuals