LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Engine Mechanical - 3.6L (3 Of 5)) >> ON-VEHICLE REPAIR INSTRUCTIONS (2 Of 2) >> Engine Oil Pressure Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition OFF.
    2. Fig 1: Identifying Oil Pressure Sensor Electrical Connector
    GM1394025Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the oil pressure sensor electrical connector.
    3. Fig 2: Identifying Engine Oil Pressure Sensor
    GM1401653Courtesy of GENERAL MOTORS CORP.
  3. Remove the oil pressure sensor.
scientia non olet · About LEMON Manuals