LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Shift Interlock System) >> Repair Instructions >> Automatic Transmission Shift Lock Actuator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Automatic Transaxle Shift Lock Actuator Electrical Connector
    GM1218843Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (L26) or Battery Negative Cable Disconnection and Connection (LY7) or Battery Negative Cable Disconnection and Connection (LS4) .
  2. Remove the center console. Refer to Front Floor Console Replacement .
  3. Disconnect the automatic transaxle shift lock actuator electrical connector (1).
  4. Remove both ends of the automatic transaxle shift lock actuator from the pivot points.
scientia non olet · About LEMON Manuals