LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Power Seat System) >> Repair Instructions >> Driver Seat and Passenger Seat Vertical Adjuster Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Seat Bolts
    GM305124Courtesy of GENERAL MOTORS CORP.
  1. Remove the front bolts.
  2. Tip the seat forward and disconnect the electrical connector from the seat electrical harness.
  3. Disengage the seat hook attachments from the floor pan.
    4. Fig 2: Identifying Vertical Drive Cables & Motor
    GM964716Courtesy of GENERAL MOTORS CORP.
  4. Tip the seat forward to expose the vertical drive cables (3 or 4).
  5. To remove either cable perform the following procedure:
    1. Bend the flexible cable at the center.
    2. Pull the cable out of the motor (1 or 2) and the drive screw.
scientia non olet · About LEMON Manuals