Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Seat Belt Retractor

Courtesy of GENERAL MOTORS CORP.

Install the belt retractor into the T-slot in the center pillar.

NOTE: Refer to Fastener Notice .

Install the seat belt retractor bolt.
Tighten: Tighten the seat belt retractor bolt to 45 N.m (33 lb ft).
Install the intermediate guide bolts.
Tighten: Tighten the intermediate guide bolts to 10 N.m (89 lb in).
Position the guide loop to the guide adjuster bracket.
Install the guide loop nut.
Tighten: Tighten the guide loop nut to 42 N.m (31 lb ft).
Install the lower center pillar trim. Refer to Center Pillar Lower Trim Panel Replacement .
Install the upper center pillar trim. Refer to Center Pillar Upper Trim Panel Replacement .