LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Engine Control System & Fuel System - 3.8L - DTC P2119 To DTC P2444 & DTC U0107) >> DTC U0107 >> Circuit/System Description

Circuit/System Description

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

The throttle actuator control (TAC) module and the powertrain control module (PCM) communicate using a dedicated serial data circuit. This serial data circuit is separate from any other serial data circuit on the vehicle. Accurate transmitting and receiving of serial data requires not only good circuit integrity, but also adequate system voltage. This diagnostic monitors the accuracy of the serial data transmitted between the TAC module and the PCM. If the PCM detects a loss of data or invalid data, or if the throttle limit is exceeded while operating in the Reduced Engine Power mode, DTC U0107 sets.