LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Engine Control System & Fuel System - 3.8L - DTC P2119 To DTC P2444 & DTC U0107) >> DTC P2440 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Relay Test

  1. Test between the normally-closed switch terminals, if any, for 0 ohm.
  2. Test between the normally-open switch terminals for infinite ohms.
  3. Test between each switch terminal and either coil terminal for infinite ohms.
  4. Connect the relay coil terminals to ground and fused power to energize the relay.
  5. Test between each switch terminal and each coil terminal for 0 volt.
  6. Test between the normally-closed switch terminals, if any, for infinite ohms.
  7. Test between the normally-open switch terminals for 0 ohm.