LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (Engine Control System & Fuel System - 3.8L - DTC P0385 To DTC P2108) >> DTC P1350 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start the engine. The engine should start and run.
  2. Monitor the Ignition Mode parameter. The parameters should transition from Bypass to IC when the engine is cranking or running.
  3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals