LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Wiper System & Washer System) >> Repair Instructions >> Windshield Wiper Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wiper Motor Screws
    GM815221Courtesy of GENERAL MOTORS CORP.
  1. Position the wiper motor to the wiper drive system module.
    2. NOTE: Refer to Fastener Notice .
  2. Install the wiper motor screws.

    Tighten:  Tighten the screws to 7 N.m (62 lb in).

    3. Fig 2: Locating Wiper Crank Arm & Nut
    GM1257438Courtesy of GENERAL MOTORS CORP.
  3. Install the wiper crank arm (1) to the wiper motor shaft.
  4. Install the wiper crank arm nut (2) to the wiper motor shaft.

    Tighten:  Tighten the nut to 30 N.m (22 lb ft).

  5. Install the wiper drive system module. Refer to Windshield Wiper System Module Replacement .
scientia non olet · About LEMON Manuals