LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Wiper System & Washer System) >> Repair Instructions >> Windshield Washer Solvent Container Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Upper Washer Solvent Container Screw
    GM1257439Courtesy of GENERAL MOTORS CORP.
  1. Position the washer solvent container to the right frame rail.
    2. NOTE: Refer to Fastener Notice .
  2. Install the lower washer solvent container screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

    3. Fig 2: Identifying Washer Pump Hose, Washer Pump Electrical Connector, & Washer Solvent Level Sensor
    GM815208Courtesy of GENERAL MOTORS CORP.
  3. Install the washer pump to the container.
  4. Install the level sensor to the container.
  5. Connect the washer solvent level sensor electrical connector.
  6. Connect the washer pump electrical connector.
  7. Connect the washer pump hose.
  8. Install the right front fender liner. Refer to Front Fender Liner Replacement .
    9. Fig 3: Identifying Upper Washer Solvent Container Screw
    GM1257439Courtesy of GENERAL MOTORS CORP.
  9. Install the upper washer solvent container screw.

    Tighten:  Tighten the screw to 10 N.m (89 lb in).

  10. Fill the washer solvent container with washer solvent.
  11. Close the hood.
scientia non olet · About LEMON Manuals