LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Wiper System & Washer System) >> Repair Instructions >> Windshield Washer Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Remove the right front fender liner. Refer to Front Fender Liner Replacement .
    3. Fig 1: View Of Washer Hose & Washer Pump
    GM815217Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the washer hose from the washer pump.
  4. Lower the Vehicle.
    5. Fig 2: View Of Washer Hose At Wiper Arms
    GM815210Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the washer hose from the wiper arms.
    6. Fig 3: View Of Washer Hose
    GM815215Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the washer hose from the air inlet grille panel.
  7. Pull the washer pump hose out from along side the right front inner fender and into the engine compartment.
  8. Remove the washer hose from the vehicle.
scientia non olet · About LEMON Manuals