LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Wiper System & Washer System) >> Repair Instructions >> Windshield Washer Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Washer Hose
    GM815215Courtesy of GENERAL MOTORS CORP.
  1. Position the washer hose to the vehicle.
  2. Route the washer pump hose down along side the right front inner fender and into the front inner fender area.
  3. Connect the washer hose to the air inlet grille panel.
    4. Fig 2: View Of Washer Hose At Wiper Arms
    GM815210Courtesy of GENERAL MOTORS CORP.
  4. Connect the washer hose to the wiper arms.
    5. Fig 3: View Of Washer Hose & Washer Pump
    GM815217Courtesy of GENERAL MOTORS CORP.
  5. Raise the vehicle.
  6. Connect the washer hose to the washer pump.
  7. Install the right front fender liner. Refer to Front Fender Liner Replacement .
  8. Close the hood.
scientia non olet · About LEMON Manuals