LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Engine Control System & Fuel System - 5.3L - DTC P0420 To DTC P3449) >> DTC P3401, P3425, P3441, or P3449 >> Component Testing >> Dynamic Test

Dynamic Test

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the VLOM harness connector at the VLOM assembly.
  2. Connect the cable that is labeled power from the displacement on demand DoD tester to the VLOM connector.
  3. Connect the power leads from the DoD tester to B+ and ground.
  4. Command each VLOM solenoid ON and OFF using the DoD tester. You should be able to hear each solenoid turn ON and OFF.
    • If the function does not perform as specified, replace the VLOM assembly.
scientia non olet · About LEMON Manuals