Component Testing

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Install the J 44152 jumper harness (20 pins) on the transmission side of the automatic transmission 20-way inline connector. See Special Tools . Using the J 35616 GM terminal test kit, measure the resistance between the TFT sensor signal circuit and the low reference circuit. Refer to Transmission Fluid Temperature Sensor Specifications .

If the resistance is not within the specified range, replace the transmission wiring harness or the TFT sensor.