Conditions for Running the DTC

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

DTCs P0030, P0036, P0053, P0054, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0120, P0128, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P0140, P0141, P0201-P0206, P0220, P0300-P0306, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0462, P0463, P0464, P0496, P0506, P0507, P1133, P1516, P2101, P2119, P2120, P2125, P2135, P2138, P2270, P2271, P2A00 are not set.
DTCs P0411, P0412, P0418, P2430-P2433, P2440, P2444, where applicable, are not set.
The Loop Status parameter indicates Closed.
The Fuel Trim Learn is enabled.
The engine coolant temperature (ECT) is between -38 and +132°C (-36.4 and +270°F).
The intake air temperature (IAT) is between -21 and +150°C (-6 and +302°F).
The manifold absolute pressure (MAP) is between 5-105 kPa.
The vehicle speed is less than 132 km/h (82 mph).
The engine speed is between 500-6,000 RPM.
The mass air flow (MAF) is between 1-510 g/s.
The barometric pressure (BARO) is more than 70 kPa.
The fuel level is more than 10 percent.
DTC P0171 or P0172 runs continuously when the above conditions have been met.