Conditions for Running the DTC: P2A00

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

DTCs P0030, P0053, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0128, P0131, P0132, P0133, P0134, P0135, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496, P1133, P1516, P2101, P2120, P2122, P2123, P2135 are not set.
DTCs P0411, P0412, P0418, P2430, P2431, P2432, P2433, P2440, P2444 are not set, where applicable.
The Engine Run Time parameter is at least 100 seconds.
The traction control, if equipped, is not active.
The control module is not commanding power enrichment (PE) or Decel Fuel Cutoff modes.
The MAF Sensor parameter is between 5-30 g/s.
The Engine Speed parameter is between 500-3,000 RPM.
The TP Indicated Angle parameter is between 3-35 percent.
The ECT Sensor parameter is more than 65°C (149°F).
The system voltage is between 10-18 volts.
The exhaust gas recirculation (EGR) flow diagnostic is not active.
The above conditions have been met for 3 seconds.