P1133 and P1134

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

DTCs P0030, P0053, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0128, P0131, P0132, P0134, P0135, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0300, P0442, P0443, P0446, P0449, P0451, P0452, P0454, P0455, P0496, P1516, P2101, P2135, P2A00 are not set.
The system voltage is between 10-18 volts.
The scan tool special functions are not active.
The HO2S Sensor 1 Heater command parameter is ON.
A current misfire condition is not detected.
The ECT Sensor parameter is more than 65°C (149°F).
The Engine Run Time parameter is at least 60 seconds.
The EVAP purge solenoid is commanded ON.
The MAF sensor parameter is between 15-30 g/s.
The Engine Speed parameter is between 1,300-3,000 RPM.
The TP Indicated Angle parameter is greater than 2 percent.
The Loop Status parameter is closed.
The vehicle is not in Park, Reverse, or Neutral.