Conditions for Running the DTC
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
P0131 and P0137
- DTCs P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496, P1516, P2101, P2119, P2135 are not set.
- DTCs P0411, P0412, P0418, P2400, P2430-P2433, P2444, where applicable, are not set.
- The system voltage is between 10-18 volts.
- The scan tool special functions are not active.
- The Air Fuel Ratio parameter is between 0.9-1.1.
- The TP Indicated Angle parameter is between 3-40 percent.
- The Loop Status parameter is closed.
- The ECT parameter is less than 131°C (267°F).
- The traction control is not active.
- The above conditions have been met for at least 3 seconds.
P0132 and P0138
- DTCs P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496, P1516, P2101, P2119, P2135 are not set.
- DTCs P0411, P0412, P0418, P2400, P2430-P2433, P2444, where applicable, are not set.
- The system voltage is between 10-18 volts.
- The scan tool special functions are not active.
- The TP Indicated Angle parameter is less than 46 percent.
- The Air Fuel Ratio parameter is between 0.9-1.1.
- The above conditions must be met for at least 3 seconds.