LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Seat Heating System & Seat Cooling System) >> Repair Instructions >> Driver Seat and Passenger Seat Back Cushion Heater Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Front Seat Back Heater Element & Electrical Connector
    GM1466651Courtesy of GENERAL MOTORS CORP.
  1. Peel off the self-stick tape from the heater element.
  2. Position the heater element over the seat back. Press firmly to engage the adhesive.
  3. Route and connect the electrical connector to the seat back cushion. Secure the wire with tie straps.
  4. Install the seat back cover. Refer to Front Seat Back Cushion Cover Replacement .
  5. Install the front seat. Refer to Front Seat Replacement - Bucket .
scientia non olet · About LEMON Manuals