LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Rear Side Door Trim Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the screw cover on the inside door handle and remove the screw.
  2. Remove the arm rest pull cup cover (1).
    3. Fig 1: Identifying Side Rear Door Trim Panel Components
    GM325947Courtesy of GENERAL MOTORS CORP.
  3. Remove the armrest pull cup screws.
  4. Starting at the door bottom, use the J 38778  to release the door trim panel retainers.
  5. Lift the trim panel up to release the top edge and move it away from the door.
  6. Using needle nose pliers, compress the plastic connector on the door handle cable end from the door panel.
    7. Fig 2: Identifying Power Window/Door Lock Switch
    GM1350695Courtesy of GENERAL MOTORS CORP.
  7. Use a flat-bladed tool to spread the power window switch retainers and remove the switch from the door panel.
  8. Remove the rear door trim panel from the vehicle.
scientia non olet · About LEMON Manuals