LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Rear Side Door Trim Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the trim panel by the door. Press the power window switch into its installed position.
  2. Connect the door handle cable to the door handle.
  3. Position the top of the trim panel at the window opening and press down.
  4. Align the fasteners into the holes in the door metal.
  5. Firmly press the door panel to seat the fasteners.
    6. Fig 1: Identifying Side Rear Door Trim Panel Components
    GM325947Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  6. Install the armrest pull cup screws.

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

  7. Install the armrest pull cup cover (1).
  8. Install the door handle screw.

    Tighten:  Tighten the screw to 3 N.m (27 lb in).

  9. Press the screw cover back into its installed position.
scientia non olet · About LEMON Manuals