LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Rear Quarter Upper Trim Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Rear Quarter Upper Trim Panel
    GM1283311Courtesy of GENERAL MOTORS CORP.
  1. Position the upper quarter trim panel into place.
  2. Install the push-in retainers to secure the trim panel (1).
    3. NOTE: Refer to FASTENER NOTICE .
  3. Install the quarter upper panel screw in the top of the panel.

    Tighten:  Tighten the quarter upper panel screw to 3 N.m (27 lb in).

  4. Install the door weatherstrip onto the pinch weld flange.
  5. Install the rear seat back. Refer to Rear Seat Back Replacement (Folding) or Rear Seat Back Replacement (Non-folding) .
scientia non olet · About LEMON Manuals