LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Rear Compartment Trim Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the rear compartment.
  2. If equipped, remove the rear compartment convenience net and net retainers.
  3. Remove the sill plate. Refer to Rear Compartment Sill Trim Plate Replacement .
  4. Remove the floor trim panel. Refer to Rear Floor Trim Plate Replacement .
  5. Remove the seat back. Refer to Rear Seat Back Replacement (Folding) or Rear Seat Back Replacement (Non-folding) .
    6. Fig 1: Identifying Rear Compartment Trim Panel Push-In Retainers
    GM900761Courtesy of GENERAL MOTORS CORP.
  6. Use J 38778  to remove the push-in retainers from the trim panels.
  7. Slide the panels off the metal supports.
  8. Remove the trim panels from the rear compartment.
scientia non olet · About LEMON Manuals