LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Rear Compartment Trim Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the trim panels in the rear compartment.
  2. Position the trim panels on the metal supports by the rear seat back.
    3. Fig 1: Identifying Rear Compartment Trim Panel Push-In Retainers
    GM900761Courtesy of GENERAL MOTORS CORP.
  3. Install the push-in retainers.
  4. Install the floor trim panel. Refer to Rear Floor Trim Plate Replacement .
  5. Install the seat back. Refer to Rear Seat Back Replacement (Folding) or Rear Seat Back Replacement (Non-folding) .
  6. Install the sill plate. Refer to Rear Compartment Sill Trim Plate Replacement .
  7. Install the rear compartment convenience net, if equipped.
  8. Close the rear compartment.
scientia non olet · About LEMON Manuals