LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Front Door Switch Bezel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the retainer tab into the trim panel and press down on the bezel to seat the retainer clips.
    2. Fig 1: View Of Pull Handle Housing
    GM1350418Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the pull handle housing screw.

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

  3. Install the pull handle housing clip.
    4. Fig 2: Identifying Window & Rearview Mirror Switches
    GM1350441Courtesy of GENERAL MOTORS CORP.
  4. Install the window and rearview mirror switches.
  5. Install the front door trim pad. Refer to Front Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals