LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Center Pillar Upper Trim Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Upper Center Pillar Trim Panel
    GM1283322Courtesy of GENERAL MOTORS CORP.
  1. Remove the door weatherstrip from the center pillar pinch weld flange to expose the upper trim panel.
  2. Grasp the trim panel firmly with both hands. Pull the panel away from the center pillar.
  3. Pull the seat belt back through the upper opening in the trim panel.
  4. Open the belt guide (1) in the bottom of the panel.
  5. Remove the trim panel from the vehicle.
scientia non olet · About LEMON Manuals