LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Center Pillar Upper Trim Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Upper Center Pillar Trim Panel
    GM1283322Courtesy of GENERAL MOTORS CORP.
  1. Position the upper trim panel to the center pillar.
  2. Route the safety belt though the guide (1) and press the guide closed.
  3. Route the safety belt though the upper opening in the trim panel.
  4. Push firmly on the trim panel in order to seat the retainers.
  5. Install the door weatherstrip to the center pillar.
scientia non olet · About LEMON Manuals