LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Immobilizer System) >> Repair Instructions >> Immobilizer System Component Programming (North America except Canada) >> 30-Minute Immobilizer Relearn

30-Minute Immobilizer Relearn

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

This 30-minute relearn procedure will relearn the fuel enable password between the body control module (BCM) and the engine control module/powertrain control module (ECM/PCM).

  1. With a master vehicle key, turn ON the ignition, with the engine OFF.
  2. Observe the security indicator. After approximately 10 minutes, the telltale will turn OFF.
  3. Turn OFF the ignition, and wait 5 seconds.
  4. Repeat steps 1-3 two more times for a total of 3 cycles or 30 minutes.
  5. IMPORTANT: The vehicle learns the fuel enable passwords on the ignition switch transition from OFF to RUN. You must turn the ignition OFF before attempting to start the vehicle.
  6. With a master vehicle key, start the vehicle. The vehicle has now learned the ECM/PCM has now learned the fuel enable password.
  7. If additional keys are required to be learned, refer to Adding Keys (North America except Canada)  or Adding Keys (Canada) .
  8. With a scan tool, clear any DTCs.