LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Engine Control System & Fuel System - 5.3L - Introduction (2 Of 2)) >> Repair Instructions >> Mass Airflow Sensor/Intake Air Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying MAF/IAT Sensor
    GM1208107Courtesy of GENERAL MOTORS CORP.
  1. Remove the air intake duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  2. Disconnect the mass air flow (MAF)/intake air temperature (IAT) sensor electrical connector (2).
    3. Fig 2: View Of MAF/IAT Sensor
    GM1556017Courtesy of GENERAL MOTORS CORP.
  3. Remove the MAF/IAT sensor bolts.
  4. Remove the MAF/IAT sensor from the air cleaner housing.
  5. Remove the MAF/IAT sensor seal, if necessary.
scientia non olet · About LEMON Manuals