LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Engine Control System & Fuel System - 5.3L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Electrical Connectors
    GM1551867Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  2. Disconnect the manifold absolute pressure (MAP) sensor electrical connector (2).
    3. Fig 2: View Of MAP Sensor
    GM1411911Courtesy of GENERAL MOTORS CORP.
  3. Remove the MAP sensor (714) from the intake manifold.
  4. Remove the MAP sensor grommet (715), if required.
scientia non olet · About LEMON Manuals