LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Engine Control System & Fuel System - 5.3L - Introduction (2 Of 2)) >> Repair Instructions >> Ignition Coil Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The following procedure shows the left side service procedure, the right side service procedure is similar.
    Fig 1: View Of Ignition Coil Main Electrical Connectors
    GM1551870Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  2. Remove the connector position assurance (CPA) retainer (3).
  3. Disconnect the ignition coil main electrical connector (4).
    4. Fig 2: View Of Ignition Coil And Bracket Assembly
    GM1411963Courtesy of GENERAL MOTORS CORP.
  4. Remove the spark plug wire(s) (724) from the ignition coil(s), as necessary.
    5. Fig 3: View Of Bracket, Bolts, Coils & Wire Harness
    GM1402020Courtesy of GENERAL MOTORS CORP.
  5. Remove the ignition coil bolts (723), as necessary.
  6. Remove the ignition coil(s) (722), as necessary.
scientia non olet · About LEMON Manuals