LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Engine Control System & Fuel System - 5.3L - Introduction (2 Of 2)) >> Repair Instructions >> Ignition Coil Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Bracket, Bolts, Coils & Wire Harness
    GM1402020Courtesy of GENERAL MOTORS CORP.
  1. Apply threadlock GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the threads of the ignition coil bolts.
  2. Install the ignition coil(s) (722), as necessary.
    3. NOTE: Refer to Fastener Notice .
  3. Install the ignition coil bolts (723), as necessary.

    Tighten:  Tighten the bolts to 8 N.m (71 lb in).

    4. Fig 2: View Of Ignition Coil And Bracket Assembly
    GM1411963Courtesy of GENERAL MOTORS CORP.
  4. Install the spark plug wire(s) (724) to the ignition coil(s), as necessary.
    5. Fig 3: View Of Ignition Coil Main Electrical Connectors
    GM1551870Courtesy of GENERAL MOTORS CORP.
  5. Connect the left ignition coil main electrical connector (4).
  6. Install the CPA retainer (3).
  7. Install the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
scientia non olet · About LEMON Manuals