LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Engine Control System & Fuel System - 5.3L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Evaporative Emission (EVAP) Purge Solenoid
    GM1551878Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister purge solenoid to the bracket.
    2. Fig 2: Identifying EVAP Canister Purge Tube
    GM1551877Courtesy of GENERAL MOTORS CORP.
  2. Connect the EVAP canister purge tube to the solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
    3. Fig 3: View Of Fuel Feed Line & Evaporative Emission (EVAP) Line
    GM1551868Courtesy of GENERAL MOTORS CORP.
  3. Connect the EVAP line (2) to the purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
    4. Fig 4: View Of Electrical Connectors
    GM1551867Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP canister purge solenoid electrical connector (1).
  5. Install the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
scientia non olet · About LEMON Manuals