LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Engine Control System & Fuel System - 5.3L - Introduction (2 Of 2)) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
    Fig 1: Identifying ECT Sensor Electrical Connector
    GM1554549Courtesy of GENERAL MOTORS CORP.
  1. Drain the cooling system below the level of the engine coolant temperature (ECT) sensor. Refer to Cooling System Draining and Filling (LS4 GE47716 Fill) or Cooling System Draining and Filling (LS4 Static Fill) .
  2. Disconnect the ECT sensor electrical connector (1).
    3. Fig 2: Locating ECT Sensor
    GM50974Courtesy of GENERAL MOTORS CORP.
  3. Remove the ECT sensor.
scientia non olet · About LEMON Manuals