LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Engine Control System & Fuel System - 5.3L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Resonator Outlet Duct Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Positive Crankcase Ventilation (PCV) Clean Air Tube
    GM1551864Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the positive crankcase ventilation (PCV) tube from the air inlet duct. Refer to Plastic Collar Quick Connect Fitting Service .
    2. Fig 2: Identifying Air Inlet Duct & Throttle Body
    GM1554558Courtesy of GENERAL MOTORS CORP.
  2. Loosen the air inlet duct clamp at the throttle body.
  3. Remove the air inlet duct from the throttle body.
    4. Fig 3: Identifying Air Inlet Duct & MAF/IAT Sensor
    GM1556020Courtesy of GENERAL MOTORS CORP.
  4. Loosen the air inlet duct clamp at the mass air flow (MAF)/intake air temperature (IAT) sensor.
  5. Remove the air inlet duct from the MAF/IAT sensor.
scientia non olet · About LEMON Manuals