LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Engine Cooling System) >> Repair Instructions >> Water Pump Replacement (LS4) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Water Pump, Bolts & Gasket
    GM1411892Courtesy of GENERAL MOTORS CORP.
  1. Install the water pump (300) and a NEW gasket (314).
    2. NOTE: Refer to Fastener Notice .
  2. Tighten the water pump bolts (318).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Install the drive belt. Refer to Drive Belt Replacement - Accessory .
  4. Install the battery tray and battery. Refer to Battery Tray Replacement (LY7) or Battery Tray Replacement (L26) or Battery Tray Replacement (LS4) .
  5. Fill the cooling system. Refer to Cooling System Draining and Filling (L26, LY7 GE 47716 Fill)  or Cooling System Draining and Filling (L26 Static Fill)  or Cooling System Draining and Filling (LY7 Static Fill)  or Cooling System Draining and Filling (LS4 GE47716 Fill)  or Cooling System Draining and Filling (LS4 Static Fill) .
scientia non olet · About LEMON Manuals