LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Engine Cooling System) >> Repair Instructions >> Coolant Recovery Reservoir Replacement (L27, LY7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Coolant Recovery Reservoir
    GM466475Courtesy of GENERAL MOTORS CORP.
  1. Reposition the coolant reservoir hose clamp (1) aside at the radiator overflow fitting.
  2. Remove the coolant reservoir hose from the radiator overflow fitting.
  3. Disconnect the coolant reservoir hose support retainer from the electrical harness.
  4. Remove the coolant reservoir nuts (2) from the shock tower studs.
  5. Remove the coolant recovery reservoir (3) from the lower retainer and the shock tower studs.
  6. Drain the coolant from the recovery reservoir into a clean container.
scientia non olet · About LEMON Manuals