LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Engine Cooling System) >> Repair Instructions >> Coolant Heater Cord Replacement (3.8L) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Coolant Heater Cord
    GM179498Courtesy of GENERAL MOTORS CORP.
  1. Remove the coolant heater cord retainer from the upper radiator support.
  2. Cut the coolant heater cord straps at the engine wiring harness.
  3. Disconnect the coolant heater cord from the coolant heater.
  4. Remove the coolant heater cord from the vehicle.
scientia non olet · About LEMON Manuals