LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Engine Exhaust System) >> Repair Instructions >> Exhaust System Insulator, Hanger, Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Exhaust Pipe Rear Hangers
    GM194710Courtesy of GENERAL MOTORS CORP.
  1. Install the exhaust pipe rear hangers to the muffler and the rear exhaust hanger brackets.
    2. Fig 2: View Of Exhaust Pipe Hanger
    GM373046Courtesy of GENERAL MOTORS CORP.
  2. Install the exhaust pipe hanger to the exhaust pipe and the exhaust hanger bracket.
    3. Fig 3: Locating Exhaust Pipe Components
    GM892635Courtesy of GENERAL MOTORS CORP.
  3. Install the exhaust pipe hanger (3) to the exhaust pipe (2) and the exhaust hanger bracket (1).
  4. Remove the support from the exhaust system.
  5. Inspect the exhaust system for underbody contact.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals