LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Engine Exhaust System) >> Repair Instructions >> Catalytic Converter Heat Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Catalytic Converter Heat Shield
    GM289491Courtesy of GENERAL MOTORS CORP.
  1. Install the catalytic converter heat shield.
  2. Install the converter heat shield rivets.
    3. Fig 2: Locating Oxygen Sensor Wiring Harness
    GM195267Courtesy of GENERAL MOTORS CORP.
  3. Install the oxygen sensor wiring harness (3) to the catalytic converter heat shield.
  4. Install the catalytic converter. Refer to Catalytic Converter Replacement .
  5. Remove the support from the exhaust system.
  6. Inspect the exhaust system for leaks and underbody contact.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals