LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Wheel Drive Shafts) >> Repair Instructions >> Wheel Drive Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Left & Right Front Wheel Drive Axles
    GM797047Courtesy of GENERAL MOTORS CORP.
  1. Install the front wheel drive axle (1, 2) into the transaxle.
  2. Verify that the front wheel drive shaft retaining ring is properly seated:
    • Grasp the inner housing and pull the inner housing outward. Do not pull on the front wheel drive axle shaft.
    • The front wheel drive axle will remain in place when the front wheel drive shaft retaining ring is properly seated.
  3. Install the front wheel drive axle into the front wheel drive shaft bearing.
  4. Connect the ball joint to the steering knuckle. Refer to Lower Control Arm Ball Joint Replacement .
  5. Connect the outer tie rod assembly to the steering knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement .
    6. NOTE: Refer to Fastener Notice .
  6. Install a new front wheel drive shaft nut. Insert a drift or a flat-bladed tool into the caliper and the rotor to prevent the rotor from turning.

    Tighten:  Tighten the nut to 160 N.m (118 lb ft).

  7. Install the stabilizer shaft link. Refer to Stabilizer Shaft Link Replacement .
  8. Install the wheel and the tire. Refer to Tire and Wheel Removal and Installation .
  9. Lower the vehicle.
  10. Inspect the transaxle fluid level.
  11. Inspect the wheel alignment. Refer to Wheel Alignment Measurement .
scientia non olet · About LEMON Manuals