LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement (JL9) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Park Brake Cable & Wheel Speed Sensor Electrical Connector
    GM741967Courtesy of GENERAL MOTORS CORP.
  1. Position the park brake cable into the support bracket and install the cable retaining pin.
  2. Install the park brake cable to the actuator lever.
    3. Fig 2: View Of Park Brake Cable
    GM802227Courtesy of GENERAL MOTORS CORP.
  3. Connect the retainer (1) that holds the cable to the support bracket.
  4. Connect the rear cable to the front cable.
      Fig 3: View Of Front Brake Cable Connected To Right Rear Cable
      GM717002Courtesy of GENERAL MOTORS CORP.
    • For the right rear cable, connect the cable (3) to the clip (2).
    • For the left rear cable, install the equalizer stud to the equalizer nut, which is part of the equalizer assembly.
  5. Adjust the park brake. Refer to Park Brake Adjustment (L26 and L32) .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals