LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Parking Brake System) >> Repair Instructions >> Parking Brake Lever Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Park Brake Cable to Caliper Caution .
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Adjusting Park Brake Tension At Equalizer Assembly
    GM732929Courtesy of GENERAL MOTORS CORP.
  2. Relieve cable tension at the park brake equalizer.
    3. Fig 2: View Of Front Brake Cable Connected To Right Rear Cable
    GM717002Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the front cable from the connector (2).
  4. Lower the vehicle.
  5. Remove the left side closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  6. Remove the left side front carpet retainer. Refer to Center Pillar Lower Trim Panel Replacement .
  7. Disconnect the electrical connector at the park brake switch.
    8. Fig 3: View Of Park Brake Pedal Assembly Retaining Nuts
    GM177091Courtesy of GENERAL MOTORS CORP.
  8. Remove the 3 park brake pedal assembly retaining nuts from the body mounting studs.
    9. Fig 4: View Of Retaining Clip
    GM648107Courtesy of GENERAL MOTORS CORP.
  9. Remove the retaining clip and disconnect the cable from the clevis.
  10. Use a 13 mm box-end wrench to release and remove the cable from the bracket on the pedal assembly.
  11. Remove the park brake pedal assembly.
scientia non olet · About LEMON Manuals