LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Equalizer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Equalizer Assembly
    GM716998Courtesy of GENERAL MOTORS CORP.
  1. Install the equalizer assembly to the front park brake cable.
    2. Fig 2: View Of Front Brake Cable Connected To Right Rear Cable
    GM717002Courtesy of GENERAL MOTORS CORP.
  2. Connect the front brake cable (1) to the right rear cable (3) at the connector clip (2).
  3. Connect the left rear brake cable and adjustment stud assembly to the equalizer assembly by installing the adjustment stud to the equalizer nut.
  4. Adjust the Park Brake System. Refer to Park Brake Adjustment (L26 and L32) .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals