LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Disc Brake System) >> Repair Instructions >> Rear Disc Brake Backing Plate Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Backing Plate & Wheel Bearing/Hub
    GM1228560Courtesy of GENERAL MOTORS CORP.
  1. Remove the wheel bearing/hub (3). Refer to Rear Wheel Bearing and Hub Replacement .
    2. IMPORTANT: The backing plate (2) is attached to the knuckle (1) through the wheel bearing hub bolts (4).
  2. Remove the backing plate (2) from the knuckle (1).
scientia non olet · About LEMON Manuals