LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Rear Suspension System) >> Repair Instructions >> Support Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Suspension
    GM1209244Courtesy of GENERAL MOTORS CORP.
  1. Position the rear suspension support in place.
  2. Install 2 locating pins in the suspension support alignment holes, one on each side of the suspension support.
    3. NOTE: Refer to Fastener Notice .
  3. Install the rear suspension support mounting bolts.

    Tighten:  Tighten the bolts to 110 N.m (81 lb ft).

  4. Remove the locating pins from the suspension support alignment holes.
  5. Position the rear wheel spindle rod to the knuckle.

    Install the retaining bolts and nuts to the knuckle.

    Tighten:  Tighten the bolts and nuts to 150 N.m (110 lb ft).

  6. Install the stabilizer shaft to the rear suspension support. Refer to Stabilizer Shaft Replacement .
  7. Connect the brake lines to the rear suspension support. Refer to Rear Brake Hose Replacement .
  8. Install the parking brake cables and the tensioner. Refer to Parking Brake Rear Cable Replacement - Left Side (J65) andParking Brake Rear Cable Replacement - Right Side (J65) .
  9. Install the exhaust pipe. Refer to Muffler Replacement (3.8L L26) or Muffler Replacement (3.6L LY7) .
  10. Install the tires and wheels. Refer to Tire and Wheel Removal and Installation .
  11. Lower the vehicle.
  12. Adjust the rear wheel alignment. Refer to Wheel Alignment Measurement .
scientia non olet · About LEMON Manuals