LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: View Of Stabilizer Shaft And Link
    GM236116Courtesy of GENERAL MOTORS CORP.
  2. Remove the stabilizer shaft link nut from the stabilizer shaft link (1) and the stabilizer shaft (2).
    3. Fig 2: View Of Stabilizer Shaft Link
    GM614968Courtesy of GENERAL MOTORS CORP.
  3. Remove the stabilizer shaft link nut (1) from the stabilizer shaft link (2) and the strut.
  4. Remove the stabilizer shaft link (2) from the vehicle.
scientia non olet · About LEMON Manuals